Yuvarlak bükme makineleri MG MH 2010 B

sheet width: 2050 mm
plate thickness: 10.0 mm ST
pre-bending: 8.0 mm ST
diameter of upper rolls: ~ 220 mm
side roll diameter: ~ 170 mm
diameter of lower rolls: ~ 190 mm
bending speed: ca. 2.0 + 5.0 m/min
Control: ELAP LYNX
oil volume: 80.0 Liter
voltage: 380 V
total power requirement: 5.5 kW
weight: 5000 kg
range L-W-H: 3500 x 1550 x 1400 mm
Current new price incl. accessories: approx. € 90.000
Special price on request

Equipment:
- Robust electro-hydraulic 4-roll plate bending machine
- 4-roll design offers a wide range of bending and rolling capabilities
- MG NC control unit ELAP LYNX
Operation – control of all rolls and machine axes
Digital position display
Manual operation via joysticks
Movable control panel
- Two central rolls driven directly by hydraulic motors
- Conical rolling possible via roll tilting
- Side roll parallelism maintained via torsion shafts
- Pre-bending on both ends
- Diameters up to 1.1 times the top roll diameter are possible
- Forged and hardened rolls (hardness: 53–55 HRC)
- Low-maintenance, robust machine design
- Permanent lubrication for all bearings
- Sturdy welded steel construction
- Selectable bending speeds (2 settings)
- Electro-hydraulic drop-end bearing for easy removal of rolled parts
- Pressure gauge/display for rolls
- Safety system (safety trip wire with switch unit)
- Operating manual (PDF)



The data for this ad was created with ModulMWS - the software solution of LogoTech oHG.

seller offer No. resale 1125-9401311